SoundPiper
@5130.adf
SoundPiper 16
ESS688 [rename to @5130.adf]
@5130.adf SoundPiper16/32
ESS1688 (takes wavetable daughtercard) [rename to @5130.adf]
Install disk,
Win 3.1x /95, Win NT 3.51 / 4.0, and OS/2 Warp drivers
Please read Dr. Jim's notes!
Pre-May 1996
Bus Arbitration Problem
WARNING! Tecmar HDE+ SCSI MCA Host
Adapter ALSO uses a @5130.adf! If you have mistakenly used the wrong adf,
get the correct adf and save it . That gives that adf the most recent date.
Run setup, choose Copy an Options Diskette. Setup will see the "new" adf
and copy over the incorrect one.
In this case, the chipsets between the SCSI adapter and
the sound card are dissimilar. No damage will occur. BUT with other adapters
with like chipsets (two SCSI controllers, for instance) I would pull the
adapter out, run Copy an Option Diskette on the "new" adf, then reinstall
the card.
SoundPiper 16
Sound Piper 16, rev 2
F1 Transorb
J1 Headphone / Speaker Out
J2 Microphone In
J3 Stereo Line In
P2 Joystick / MIDI port
P3 CD Rom R-G-G-L
P4 MM link??? |
U1 Altera EPM7096QC100-15
U4 ESS AudioDrive ES688F
U7 JRC M4201F / M4242F
U9 NS LM1877N-9
U10 Yamaha OPL YMF262-M
X1 14.13 MHz?
0 |
SP32MCA
3-D Surround Sound Daughter Card
The two internal ports may be changed. My 16-2a has a simple 16 pin
header, minus one pin, no shroud. P3 is a shrouded header that points upward
along the PCB.
AdapterId 05130h SoundPiper 16/32(tm)
Adapter
I/O Port
The SoundPiper may occupy one of two
different I/O port ranges
<Port
240>, Port 220, Disabled
Interrupt Level
The SoundPiper may occupy one of four different Interrupt
levels
<Level 5>,
Level 7, Level 10, Level 9, Disabled
DMA Arbitration Level
The SoundPiper may occupy one of three different DMA Arbitration
levels.
<Level 1>,
Level 0, Level 3, Disabled
Joystick Enable
The SoundPiper has an joystick interface available
<Enabled - Port 200-201>,
Disabled
Joystick Wait States
[16/32 only]
The SoundPiper has a Wait-State generator for joystick
accesses. The number of wait-states may be adjusted to permit some software
that use the joystick to work better on the PS/2.
<2 Wait States>,
3 Wait States, 1 Wait State, 0 Wait States
ADLIB/OPL-3 Port Enable
[16/32 only]
The SoundPiper has an ADLIB/OPL-3 compatible interface
available. This interface is typically used as the MIDI Synthesizer. Disabling
this port may cause your MIDI playback under Windows to stop functioning.
<Enabled -
Port 388-38B>, Disabled
MPU401 Port Enable
[16/32 only]
The SoundPiper has an MPU-401 compatible interface available.
This interface is typically used to communicate with an External MIDI device
or the Internal Wave Table daughter card on a SoundPiper 32.
<Enabled -
Port 330-33F>, Disabled
9595 Main Page
|